February 3

Steampunk 3D printed Guitar

steampunk-3D-Printed-Guitar

Steampunk 3D printed Guitar

The Steampunk 3D printed guitar: A tribute to one of my all-time favorite guitars, the Telecaster. This guitar features a 3D printed body with moving gears and piston. The entire body, including all its moving components is printed as a single component, with no further assembly required. The Steampunk paint job was done by New Zealand airbrush artist Ron van Dam.

The body was printed using selective laser sintering (SLS) by 3D Systems, in the USA, on an sPro 230 SLS machine out of Duraform (nylon) material.

Steampunk 3D printed Guitar

steampunk-3D-Printed-Guitar

Neck : Warmoth Pro Telecaster maple neck with maple fret board, 22 frets, 25 1/2″ scale, 42.86mm (1 11/16″) width GraphTech White TUSQ, 6150 sized jumbo frets, 10-16″ compound radius fret board, black inlay dots

Body : 3D printed Duraform PA outer body, with maple inner core, airbrushed steampunk paint job, and sprayed with clear satin lacquer

Bridge : Schaller 475, 6 String Flat Mount Bridge, Chrome

Pickups : Dimarzio Area-T (neck) and Fast Track (bridge)

Tuning Heads : Gotoh Mini 510 Locking Tuners, Chrome

Controls : 3 positon pickup select switch, Volume knob, Tone knob, Gear motor on/off switch

Other : Schaller Strap Locks, D’Addario strings, low-cost hard case for safe shipping

Weight : 3.2Kg


Copyright 2021. All rights reserved.

Posted February 3, 2021 by admin in category "3d-printed-guitar

1 COMMENTS :

Leave a Reply to william Wright Cancel reply

Your email address will not be published.